Detach the document support plates when moving or packing the scanner. Calibration Sheet 1 Connect the scanner to the computer. Please contact your network administrator if you do not know your IP address. If the document has been inserted on top of the two paper sensors at the front and rear of the scanner, the document thickness is automatically detected. Make sure that the document support unit is not attached at an angle.
|Date Added:||19 June 2007|
|File Size:||10.56 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
If a key is pressed or an operation such as inserting a document is performed while the scanner is in power-saving mode, the scanner returns to the standard operating mode. Side cover Rubber feet Fixing plate Fixing plate Coin screw Graphetc screw Center bar Fixing plate Notch Groove 4 Secure the side stays in place by tightening up the four center bar fixing screws see 2 above.
If the document has been inserted on top of the two paper sensors at the front and rear of the scanner, the document thickness is automatically detected. Top cover Open the top cover to clean the document hold-down unit and transparent contact plates.
Page 37 When the setting will be performed from a location that a router is used to access, depending on the type of router used, there may be locations that cannot be searched. Distance Correction The values entered here must be within the range of the distance correction.
Index of /Scanner/Graphtec/TrainingVideos/Paradigm/CS/Images
This technology eliminates timeconsuming re-alignment and recalibration of the scanning device and means no warm-up time scanners are ready to go within seconds of turning the power on. The scanner name displayed in the windows is the name of the scanner connected to the computer. One of the standout features of the CS scanner is its ability to scan rigid, thick originals”? In this case, make the setting cs6000 the same segment.
Page 81 11 Click the Fit icon to display the entire image, and check whether there is any discrepancy in color. Plug the Ethernet cable into the Ethernet connector located on the right-hand side of the scanner unit. Normal documents [Up to 1. Page 54 7 The screen shown below is displayed when the wizard has finished installing the c6s00. Lift the plates up and out of the slots to detach them.
The distance will be corrected the next time a document is scanned. Calibration of the document-thickness settings for the CS scanner is performed in the status that is set for thin documents. The safety sensor has been activated. Page 20 Screw A Screw A Frame 3 7 Cs60 ensure that you remove the cushion material that is included below the document hold-down unit before using the product.
Attaching The Document Support 2. Daily Maintenance 90 degrees.
Index of /Scanner/Graphtec/TrainingVideos/Paradigm/CS600/Images
Latch Latch The above illustration is of the model. Page 85 – The image quality has dropped Page 86 Page 87 – Smudges not appearing in the original do Screw A Screw Grapgtec Frame 3 7 Always ensure that you remove the cushion material that is included below the document hold-down unit before using the product.
If the unit is not attached correctly, the document may not be fed correctly. Install the Graphtec Network Utility. CS thin document up to 1. Page of Go. The nominal display resolution equals to x pixels.
The thick document that has been inserted Press the ITA key to raise the top cover. Search for drivers by ID or device name Known devices: The scanners are designed for use by graphic arts, fine-art, photography, prepress, reprographics, and sign professionals.
The top cover will start to rise. Paper sensors The above illustration is of the model. Document support plate 2 Attach the second document support plate in the same manner. Such problems may be avoided by taking the following corrective measures.